|
|
|
|
|
|
|
|
|
|
How to avoid the failure of the raymond mill in production?
|
|
During the operation of Raymond mill, failures of the devices is inevitable.If the failure of the Raymond mill occurs many times, it will affect the normal production of the equipment.At the same time, the inspection and elimination of the fault, but also need to spend a certain amount of money, to increase the production cost for users.So, here's how to avoid a breakdown.
First, make a thorough check before starting the machine.
Before the user grinds the material to make powder, must carry on the comprehensive inspection to each part of the equipment.Check as follows: make sure bolts and screws are tightened;
Ensure adequate lubricating oil;Ensure the connection between the parts of the raymond mill is firm;To report the normal voltage of the motor.If you can do a good job in the inspection of the Raymond mill before starting up, the user can find out the potential problems in time and solve them, which is an important step to reduce the number of failures of the Raymond mill.
Secondly, pay attention to the operation of the equipment when working.
Staff in the use of the Raymond mill, to always pay attention to the operation of the Raymond mill, observe the operation of various parts, including the dust removal effect of the dust collector, as well as the operation of the motor to see.The working condition of the raymond mill was judged by the amount of powder and the fineness of powder.
Always pay attention to the changes in each link of the equipment production, in the case of finding abnormal, timely safe and reliable processing, to prevent the occurrence of greater failure.
Thirdly, do the maintenance work well.
After the operation of the raymond mill is finished, the cleaning and maintenance of the Raymond mill should be done.
After the shutdown, the Raymond mill cleaned the residual materials and dust impurities in the equipment in a timely manner, and checked the use of lubricating oil, regularly and quantitatively added lubricating grease, and observed the wear of the wearing parts of the equipment.
Replace the parts as soon as it is found that the parts are badly worn.
In case of bad weather, it is necessary to protect the equipment from corrosion.
|
|
|
|
|
|
|
|
|
|
|
